Eco-Line SCs - User Configurable Versions for mV, V and mA DC

The User Configurable Versions (UCV) of the Eco-Line Signal Converters can be easily configured for the following -

Inputs:

4-20 mA, 0-20 mA, 0-100 mV, 0-1 V, 0-10 V, ±10V and 0-100 V and any values within these ranges.

Outputs:

4-20 mA, 0-20 mA, 0-5 V, 0-10 V and ±10V and any values within these ranges.

So for example you can set up a device for 4-12 mA input and 0-10 V output if you like.

The configuration is done using DIP switches beneath the decals on the left side of the enclosure, the device trimpots and a recessed push button on the front of the unit.

The User Manual provides a comprehensive guide to the selection of input and output ranges and the calibrations/configurations.

The output of the unit can also be used to generate various inputs if you do not have a process signal source or generator. Best is to have a good multi-meter and a process signal source. You can also use the actal plant signals to calibrate if you can get to the minimum and maximum input values and the internal trimpots can be used to configure the output.

We also include addition front stickers of the various standard inputs and outputs for you to use on your customized device.

In this version we include an Input LED which can be used to show that the input is within a desired operating range. it will be off if the input is not detected, flash slowly if the input is low, remain on if within the range and flash fast if it is too high.

Similarly an Alarm LED is included at the output to indicate high and low limit values. You can set up up all of these values.